Specifications

www.cascadiadvrt.com [phone] 25 | Page
2.4.3CONTROLLER&PTZSetup
TocontrolthePTZfunctionsofthecamera,connectacontrollertotheRS‐485port.
① ConnecttheRS‐485cablesofthePTZcameratotheRS‐485portontherearpanel.

② PressthePTZmenubutton.ThePTZmenuscreenisdisplayedasbelow.
 
Figure2.4.4PTZControlSetupScreen

Note: For speed dome cameras that support RS‐485, connect them directly to theRS‐485 port. If the camera is
controlledwithRS‐232C,useaRS‐485to
RS‐232Csignalconverter.
OnthePTZ controlsetupscreen,youcanselectorsettheprotocoltypeofthecamerathatisthesameastheone
installedonthesite.IfthecamerahasaspecificcameraID,selectthecameraIDusingthemouseorthecontrol
buttonsoftheremotecontrol.
ThefollowingoptionsareavailableonthePTZsetupscreen:
CHANNEL(CorrespondstothePTZcamera’sID)
NAME(Protocoltype)
SPEED(BaudRate)(19200,14400,9600,4800,or2400)
ID(0~63)

2.4.4MotionZoneSetup
SelectMOTIONZONEusingthemouseorthecontrolbuttonsontheremotecontrolandselecteitherPARTIALZONE
orFULLZONEusingthemousecontrol.ThedefaultvalueisFULLZONE.
IfFULLZONEisselected,themotionzonegridscreenisnotdisplayed.Onlysetthelevelofsensitivity
forMOTION
SENSITIVITY. 
