Specifications

32 | Page
2‐4.Setup–DeviceMode
IntheSETUPmenu,selecttheDEVICEtab.Then,thedevicemenuisdisplayedaspicturedbelow.Navigatethrough
themenuitemsusingthemouseorthecontrolbuttonontheremotecontrolandchangethevalueofthemenuitem.

Figure3.4.1.DeviceModeSetupScreen

Table3.4.1.MenuItemsinDeviceSetupScreen 
Item Description
ALARMOUT Setthesensor,motion,andvideolossforeachalarm.
CONTROLLER&PTZ SetthePTZbaudrate,protocol,andID.
SPOT‐OU T Setthealldetailsforspotmonitoring.Itsupports2spot‐outs.
CHANNEL Selectspecifiedchannelformotionzonesetup.
MOTIONZONE SelecteitherFullZoneorPartialZoneformotionsensing.
MOTIONSENSITIVITY Setthemotionsensitivityforthespecifiedchannel.
Controlthemotionsensitivityfrom1to9.
KEYTONE Enable/disablekeytone.
REMOTECONTROLID SelectanIDofremotecontrol.
1.SelectIDnumber.
2.PressthesamenumberasIDsetinDVRontheremotecontrol.
3. An icon will be displayed on the Live Screen that corresponds to the
remotecontrolIDnumber.0
Theoptionsarefrom0to99
SENSOR SelectsensorNOfrom1to4
TYPE Set the type of sensor for the specified channel. Options are: OFF, N/O
(normalopen),andN/C(normalclosed).