Installation Guide

Installation Steps
Turn off the power at fuse or circuit box
1.Cut
the
“
H
”
plastic
buckles
with
scissor
when
take down the PE bags. (See Fig.1)
2. Remove the mounting plate from fixture by
unscrewing two ball nuts.
3.Attach the mounting plate to the outlet box by using
two mounting screws.
4. Pull out the source wires from the outlex box. Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually
white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding screw, and then connect it to the house grounding wire with the wire connector.
Carefully put the wires back into the outlet box.
5. Attach the fixture to the mounting plate by inserting two fixture mounting screws into the holes, then tighten the
fixture by screwing the ball nuts into the fixture mounting screw.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Plate Mounting Screw (B) Green
Grounding
Fixture Mounting Wire Connector
(E)
Assembly Kit
(A) Screw (C) Screw (D)
5758MM (1 SET)
Lock Nut (F) Ball Nut (G) Pure Shell(H) Fishing Line(I)
A: 16"
B: 11.5"
170922