Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0072 / C0073
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box.
140730
Page 1
Mounting Strap (A)
Short Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Decorative cup (N)
Finial (O)
Hardware Package (included):
Assembly Instructions:
Threaded Pipe (K)
Lock Washer (J)
1. Thread two short screws to the mounting strap, and secure with
two lock nuts. Adjust the length of the screws if necessary.
2. Attach the mounting strap to the outlet box using two long
screws.
3. Pull out the source wires from the outlet box. Make wire
connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the
fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the
fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually bare wire) to the
mounting strap with the green grounding screw. Then
connect it to the house grounding wire with a wire nut. If your
outlet box does not have a house grounding wire, then wrap
the fixture grounding wire around the green grounding screw.
Carefully put the wires back into the outlet box.
4. Attach the canopy to the mounting strap: insert the short screws
through the two holes, and secure with two ball nuts.
5. Install bulbs (not included). See relamping label at socket area
or packaging for maximum allowed wattage.
6. Screw the threaded pipe into the coupling, secure it
with a lock washer and hex nut. Then slip a tube,
small cap with the open side facing upward, fitter
with the open side facing upward through the
threaded pipe, secure them with hex nut.
7. Attach the glass shade to the ceiling pan: Insert the threaded
pipe through the hole in the glass shade, then attach
decorative cup to end of threaded pipe using finial to secure.
Turn on the power at the main fuse or circuit breaker box.
Long Screw (D)
Ball Nut (G)
Fitter (L)
Socket Set
Canopy
Outlet Box
House Grounding Wire
Wire Nut (E)
Long Screw (D)
Mounting Strap (A)
Green Grounding Screw (C)
Lock Nut (F)
Short Screw (B)
Bulb Type A Max.100W
(not included)
Decorative Cup (N)
Finial (O)
Small Cap (M)
Tube (H)
Coupling
Lock Washer (J)
Hex Nut (I)
Threaded Pipe (K)
Glass Shade (P)
Hex Nut (I)
Ball Nut (G)
Tube (H)
Hex Nut (I)
Fitter (L)
Small Cap (M)