User's Manual Part 4
Release8ReferenceInformation
Issue2,November2007 Draft5forRegulatoryReview 495
FCC ID Industry
Canada
Cert
Number
Frequencies Module
Families
Antenna or
Reflector
Maximum
Transmitter
Output
Power
--- 109W-5400 20 MHz channels,
centered on 5495-
5575 and 5675-
5705 MHz in 5 MHz
increments (within
the 5470-5725 MHz
U-NII band with
5600-5650 MHz
excluded)
5400 BH,
SM, AP
7 dBi internal 23 dBm
(200 mW)
5400 BH,
SM
7 dBi internal +
18 dB reflector
5 dBm
(3.2 mW)
7 dBi internal +
9 dB lens
14 dBm
ABZ89FC5804 109W-5700 20 MHz channels,
centered on 5735-
5840 MHz in 5 MHz
increments (within
the 5725-5850
MHz ISM band)
5700 BH,
SM, AP
7 dBi internal 23 dBm
(200 mW)
5700 BH,
SM
7 dBi internal +
18 dB reflector
23 dBm
(200 mW)
7 dBi internal +
10 di lens
23 dBm
(200 mW)
ABZ89FT7629 --- 10 MHz channels,
centered on 5476-
5719 in 0.5 MHz
increments (within
the 5470-5725 MHz
U-NII band)
5440 AP 17 dBi
connectorized
antenna (60° x
5° 3 dB beam
width)
10 dBm
5440 SM 17 dBi
integrated
antenna (18° x
18° 3 dB beam
width)
10 dBm
36.2.2 IndustryCanada(IC)Notification
This device complies with RSS-210 of Industry Canada. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause
undesired operation.
Users should be cautioned to take note that in Canada high power radars are allocated
as primary users (meaning they have priority) of 5250 – 5350 MHz and 5650 – 5850 MHz
and these radars could cause interference and/or damage to license-exempt local area
networks (LELAN).
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to RSS-210 of Industry Canada. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio-frequency energy and, if not installed
and used in accordance with these instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or