User's Manual Part 4

Release8ReferenceInformation


Issue2,November2007 Draft5forRegulatoryReview 492
Command System help Definition Notes
ping
Send ICMP ECHO_REQUEST
packets to network hosts
Syntax: ping IPaddress. Sends an ICMP
ECHO_REQUEST to IPaddress and waits for
a response. If a response is received, the system
returns IPaddress is alive.
If no response is received, the system returns no
answer from IPaddress.
reset
Reboot the unit
Syntax: reset. Forces the module to perform a
hard (FPGA and CPU) module reset. (See
fpga_conf.)
rm
Remove (unlink) files
Syntax: rm filename. Remove filename.
syslog
Display system event log:
syslog <optional
filename>
Syntax: syslog. Displays the contents of the
system log. Syntax: syslog filename. Saves
the contents of the system log to filename.
Caution: overwrites filename if it already
exists.
telnet
Telnet application
Syntax: telnet hostIPaddress. Launches
the telnet client application on the Cyclone
module.
tftp
tftp application
Syntax: tftp hostIPaddress. Launches the
tftp client application on the Cyclone module.
update
Enable automatic SM code
updating
Syntax: update actionlist.txt. Enables
the automated update procedure that
actionlist.txt specifies. (Supported for
only the Access Point Module.)
updateoff
Disable automatic SM
code updating
Syntax: updateoff. Disables the
automated update procedure.
version
Display the software
version string
Syntax: version. Displays the module
version string, which contains the
software/firmware/hardware versions, the
module type, and the operating
frequency.