User's Manual Part 4

Release8OperationsGuide


Issue2,November2007 Draft5forRegulatoryReview 474
Figure 179: NAT DHCP Statistics tab of SM, example
• verify that DHCP is operating as configured.
6. After connectivity has been re-established, reinstall network elements and
variables that you removed in Step 1.
end of procedure
32.5.3 SMDoesNotRegistertoanAP
To troubleshoot an SM failing to register to an AP, perform the following steps.
Procedure 50: Troubleshooting SM failing to register to an AP
1. Access the Radio tab in the Configuration page of the SM.
2. Note the Color Code of the SM.
3. Access the Radio tab in the Configuration page of the AP.
4. Verify that the Color Code of the AP matches that of the SM.
5. Note the Radio Frequency Carrier of the AP.
6. Verify that the value of the RF Frequency Carrier of the AP is selected in the
Custom Radio Frequency Scan Selection List parameter in the SM.