User's Manual Part 3
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegula toryReview 358
Figure 134: Mounting assembly, exploded view
19.10 INSTALLINGABHTIMINGMASTER
To install the Cyclone BHM, perform the following steps:
Procedure 30: Installing the BHM
1. Access the General tab of the Configuration page in the BHM.
2. If this is a 20-Mbps BH, set the 2X Rate parameter to Disabled (temporarily for
easier course aiming).
3. Click the Save Changes button.
4. Click the Reboot button.
5. After the reboot is completed, remove power from the BHM.
6. Choose the best mounting location for your particular application.
7. Attach the BHM to the arm of the Cyclone Passive Reflector dish assembly as
shown in Figure 135.
RECOMMENDATION:
The arm is molded to receive and properly aim the module relative to the aim of
the dish. ( See Figure 132 on Page 356.) Stainless steel hose clamps should be
used for the attachment.