User's Manual Part 3
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 326
Low Priority Downlink CIR
See
◦ Committed Information Rate on Page 86
◦ Setting the Configuration Source on Page 295.
18.5.6 SecurityTaboftheBHS
An example of the Security tab in a BHS is displayed in Figure 112.
Figure 112: Security tab of BHS, example
In the Security tab of the BHS, you may set the following parameters.
Authentication Key
Only if the BHM to which this BHS will register requires authentication, specify the key
that the BHS should use when authenticating. For alpha characters in this hex key, use
only upper case.
NOTE:
Cyclone recommends that you enter 32 characters to achieve the maximal
security from this feature.