User's Manual Part 3

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 325
The SNMP tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on the Configuration page are
recorded in flash memory. However, these changes do not apply until the next reboot of
the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
18.5.5 QualityofService(QoS)TaboftheBHS
An example of the Quality of Service tab of the BHS is displayed in Figure 111.
Figure 111: Quality of Service (QoS) tab of BHS, example
In the Quality of Service (QoS) tab of the BHS, you may set the following parameters.
Low Priority Uplink CIR
See
◦ Committed Information Rate on Page 86
◦ Setting the Configuration Source on Page 295.