User's Manual Part 3

Release8OperationsGuide


Issue2,November2007 Draft5forRegula toryReview 446
In the Frame Calculator tab, you may set the following parameters.
Software Version Transmitter
From the drop-down menu, select the Cyclone software release that runs on the AP(s).
Software Version Receiver
From the drop-down menu, select the Cyclone software release that runs on the SM(s).
Transmit Sync Input
If the APs in the cluster
◦ receive sync from a CMMmicro, select Sync to Received Signal (Power Port).
◦ receive sync from a CMM2, select Sync to Received Signal (Timing Port).
◦ are self timed, select Generate Sync Signal.
Link Mode
For AP to SM frame calculations, select Multipoint Link.
Max Range
Set to the same value as the Max Range parameter is set in the AP(s).
Air Delay
Leave this parameter set to the default value of 0 bits.
Scheduling
Initially select Software.
Mobility
Leave the default value of Off selected.
Wireless/Wired
Leave the default value of Wireless Link selected.
Platform Type Transmitter
Use the drop-down list to select the hardware series (board type) of the AP.
Platform Type Receiver
Use the drop-down list to select the hardware series (board type) of the SM.
Frequency Band
Use the drop-down list to select the radio frequency band of the AP and SM.
External Bus Frequency Transmitter
Leave this parameter set to the default value of 40.
External Bus Frequency Receiver
Leave this parameter set to the default value of 40.