User's Manual Part 3
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 312
In the DiffServe tab of the BHM, you may set the following parameters.
CodePoint 1
through
CodePoint 47
CodePoint 49
through
CodePoint 55
CodePoint 57
through
CodePoint 63
The default priority value for each settable CodePoint is shown in
Figure 113. Priorities of 0 through 3 map to the low-priority channel;
4 through 7 to the high-priority channel. The mappings are the same
as 802.1p VLAN priorities.
Consistent with RFC 2474
• CodePoint 0 is predefined to a fixed priority value of 0
(low-priority channel).
• CodePoint 48 is predefined to a fixed priority value of 6
(high-priority channel).
• CodePoint 56 is predefined to a fixed priority value of 7
(high-priority channel).
You cannot change any of these three fixed priority values. Among
the settable parameters, the priority values (and therefore the
handling of packets in the high- or low-priority channel) are set in
the AP for all downlinks within the sector and in the SM for each
uplink. See DSCP Field on Page 87.
The DiffServe tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on the Configuration page are
recorded in flash memory. However, these changes do not apply until the next reboot of
the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.