User's Manual Part 3

Release8OperationsGuide


Issue2,November2007 Draft5forRegula toryReview 419
26.4.3 MessagesthatFlagAbnormalEvents
The messages listed in Table 63 flag abnormal events and, case by case, may signal the
need for corrective action or technical support. See Troubleshooting on Page 469.
Table 63: Event Log messages for abnormal events
Event Message Meaning
Expected LUID = 6 Actual
LUID = 7
Something is interfering with the control messaging of the
module. Also ensure that you are using shielded cables to
minimize interference. Consider trying different frequency
options to eliminate or reduce interference.
FatalError()
The event recorded on the line immediately beneath this
message triggered the
Fatal Error().
Loss of GPS Sync Pulse
Module has lost GPS sync signal.
Machine Check Exception
This is a symptom of a possible hardware failure. If this is
a recurring message, begin the RMA process for the
module.
RcvFrmNum = 0x00066d
ExpFrmNum = 0x000799
Something is interfering with the control messaging of the
module. Also ensure that you are using shielded cables to
minimize interference. Consider trying different frequency
options to eliminate or reduce interference.
System Reset Exception -- External
Hard Reset
The unit lost power or was power cycled.
System Reset Exception -- External
Hard Reset WatchDog
The event recorded on the preceding line triggered this
WatchDog message.
26.4.4 MessagesthatFlagNormalEvents
The messages listed in Table 64 record normal events and typically do not signal a need
for any corrective action or technical support.
Table 64: Event Log messages for normal events
Event Message Meaning
Acquired GPS Sync Pulse.
Module has acquired GPS sync signal.
FPGA Features
Type of encryption.
FPGA Version
FPGA (JBC) version in the module.
GPS Date/Time Set
Module is now on GPS time.
PowerOn reset from Telnet
command line
Reset command was issued from a telnet session.
Reboot from Webpage
Module was rebooted from management interface.
Software Boot Version
Boot version in the module.
Software Version
Cyclone release version and authentication method for the
unit.
System Log Cleared
Event log was manually cleared.