User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 243
NOTE:
Where space is limited for subnet allocation, be advised that an SM need not
have an operator-assigned IP address. The SM is directly accessible without an
LUID if either the SM Color Code parameter is set to 0 or the AP has a direct
Ethernet connection to the SM.
The IP Configuration page also provides the following buttons.
Save Changes
When you click this button, any changes that you made on this tab are recorded in flash
memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
18.1.3 RadioTaboftheAP
An example of the Radio tab of the AP is shown in Figure 77.
Figure 77: Radio tab of AP (900 MHz), example