User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 232
In addition, when you click Reboot, the following events occur and are logged:
• The CMMmicro reboots.
• Any AP or BH that receives power from the CMMmicro loses power and thus
also reboots.
• Any AP or BH that does not receive power but receives sync from the CMMmicro
loses and then regains sync.
16.5.4 ConfiguringModulesforConnectiontoCMMmicro
After configuring the CMMmicro, configure the APs and BHs as follows. In each AP or BH
that connects to a CMMmicro, you must set the Sync Input parameter of the
Configuration page of that module to Sync to Received Signal (Power Port).
See
• Sync Input on Page 239.
• Sync Input on Page 299.
16.5.5 EventLogPageoftheCMMmicro
This page may contain information that can be useful under the guidance of Cyclone
technical support. For this reason, the operator should not clear the contents of this page
before contacting technical support.
16.5.6 GPSStatusPageoftheCMMmicro
An example of the CMMmicro GPS Status page is displayed in Figure 73.
Figure 73: GPS Status page of CMMmicro, example