User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 230
RECOMMENDATION:
For more information on CIDR, execute an Internet search on “Classless
Interdomain Routing.”
The default treatment is to allow all networks access.
Trap Address
Specify the IP address (xxx.xxx.xxx.xxx) of one to ten servers (Prizm or NMS) to which
trap information should be sent. Trap information informs the monitoring systems that
something has occurred. For example, trap information is sent
• after a reboot of the module.
• when Prizm or an NMS attempts to access agent information but either
• supplied an inappropriate community string or SNMP version number.
• is associated with a subnet to which access is disallowed.
Permission
Select Read Only if you wish to disallow any parameter changes by Prizm or an NMS.
Site Name
Specify a string to associate with the physical module. This parameter is written into the
sysName SNMP MIB-II object and can be polled by an NMS. The buffer size for this field
is 128 characters.
Site Contact
Enter contact information for the module administrator. This parameter is written into the
sysContact SNMP MIB-II object and can be polled by an NMS. The buffer size for this
field is 128 characters.
Site Location
Enter information about the physical location of the module. This parameter is written into
the sysLocation SNMP MIB-II object and can be polled by an NMS. The buffer size for
this field is 128 characters.
The CMMmicro Configuration page also provides the following buttons.
Enable 802.1Q Tagging
Once 802.1Q Tagging is enabled and an 802.1Q VLAN ID is set, only frames that are
VLAN tagged with the configured tag value will be accepted by the management
controller of the CMMmicro. All frames outgoing from the management controller of the
CMMmicro will have an 802.1Q VLAN tag, set to the configured VLAN ID.
802.1Q VLAN ID
Once 802.1Q Tagging is enabled and an 802.1Q VLAN ID is set, only frames that are
VLAN tagged with the configured tag value will be accepted by the management
controller of the CMMmicro. All frames outgoing from the management controller of the
CMMmicro will have an 802.1Q VLAN tag, set to the configured VLAN ID.