User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 216
Site Name
This field indicates the name of the physical module. You can assign or change this
name in the SNMP tab of the BHM Configuration page. This information is also set into
the sysName SNMP MIB-II object and can be polled by an SNMP management server.
Site Contact
This field indicates contact information for the physical module. You can provide or
change this information in the SNMP tab of the BHM Configuration page. This information
is also set into the sysName SNMP MIB-II object and can be polled by an SNMP
management server.
Site Location
This field indicates site information for the physical module. You can provide or change
this information in the SNMP tab of the BHM Configuration page.
Scheduling Type
This field indicates the type of frame scheduler that is active in the BHM.
16.4.6 ConcludingtheTestofPoint‐to‐PointLinks
To conclude the test, perform the following steps.
Procedure 16: Verifying and recording information from the BHM
1. Confirm that the GPS Sync Pulse Status field indicates Generating Sync.
NOTE:This indication confirms that the BHM is properly functional.
2. While your browser is set to this BHM Status page, note (or print) the values of
the following fields:
• Device type
• Software Version
• Software BOOT Version
• Board Type
• FPGA Version
3. Systematically ensure that you can retrieve this data when you prepare to deploy
the BHM.
end of procedure