User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 215
is secured by DES or AES encryption (see Encrypting Cyclone Radio Transmissions on
Page 375). When you request technical support, provide the information from this field.
Software BOOT Version
This field indicates the version of the CYCLONEBOOT file. If you request technical
support, provide the information from this field.
Board Type
This field indicates the series of hardware. See Designations for Hardware in Radios on
Page 372.
FPGA Version
This field indicates the version of the field-programmable gate array (FPGA) on the
module. When you request technical support, provide the information from this field.
Uptime
This field indicates how long the module has operated since power was applied.
System Time
This field provides the current time. If the BHM is connected to a CMM, then this field
provides GMT (Greenwich Mean Time). The BHS that registers to the BHM inherits the
system time.
Last NTP Time Update
If the Time & Date page of the module specifies that time should be received from an
NTP server, then this field indicates when the time was last updated by a Network Time
Protocol (NTP) server.
Ethernet Interface
This field indicates the speed and duplex state of the Ethernet interface to the module.
Registered SM Count
This field confirms that only one BHS is registered to the BHM.
GPS Sync Pulse Status
This field indicates the status of synchronization as follows:
• Generating sync indicates that the module is set to generate the sync pulse.
• Receiving Sync indicates that the module is set to receive a sync pulse from an
outside source and is receiving the pulse.
• ERROR: No Sync Pulse indicates that the module is set to receive a sync pulse
from an outside source and is not receiving the pulse.
NOTE:
When this message is displayed, the BHM transmitter is turned off to
avoid self-interference within the Cyclone system.