User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 206
Figure 62: Quick Start tab of BHM, example
Quick Start is a wizard that helps you to perform a basic configuration that places a BHM
into service. Only the following variables must be configured:
• RF Carrier Frequency
• Synchronization
• Network IP Address
In each page under Quick Start, you can
• specify the settings to satisfy the requirements of the network.
• review the configuration selected.
• save the configuration to non-volatile memory.
Proceed with the test setup as follows.