User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 204
Site Contact
This field indicates contact information for the physical module. You can provide or
change this information in the SNMP tab of the AP Configuration page. This information
is also set into the sysName SNMP MIB-II object and can be polled by an SNMP
management server.
Site Location
This field indicates site information for the physical module. You can provide or change
this information in the SNMP tab of the AP Configuration page.
Scheduling Type
This field indicates the type of frame scheduler that is active in the AP.
MP Double Rate
This field indicates whether 2X modulation rate is enabled for the sector.
16.3.9 ConcludingtheTestofPoint‐to‐MultipointLinks
To conclude the test, perform the following steps.
Procedure 11: Verifying and recording information from the AP
1. Confirm that the GPS Sync Pulse Status field indicates Generating Sync.
NOTE:This indication confirms that the AP is properly functional.
2. While your browser is directed to this General Status tab, note (or print) the
values of the following fields:
• Device type
• Software Version
• Software BOOT Version
• Board Type
• FPGA Version
3. Systematically ensure that you can retrieve this data when you prepare to deploy
the AP.
end of procedure
16.4 CONFIGURINGAPOINT‐TO‐POINTLINKFORTEST
NOTE:
This section supports the Cyclone 10- and 20-Mbps Backhaul Modules. To find
setup and configuration guides that support the OFDM Series Backhaul
Modules, refer to Products Not Covered by This User Guide on Page 34.
Perform the following steps to begin the test setup.