User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 203
Board Type
This field indicates the series of hardware. See Designations for Hardware in Radios on
Page 372.
FPGA Version
This field indicates the version of the field-programmable gate array (FPGA) on the
module. When you request technical support, provide the information from this field.
Uptime
This field indicates how long the module has operated since power was applied.
System Time
This field provides the current time. If the AP is connected to a CMM, then this field
provides GMT (Greenwich Mean Time). Any SM that registers to the AP inherits the
system time.
Last NTP Time Update
This field displays when the AP last used time sent from an NTP server. If the AP has not
been configured in the Time tab of the Configuration page to request time from an NTP
server, then this field is populated by 00:00:00 00/00/00.
Ethernet Interface
This field indicates the speed and duplex state of the Ethernet interface to the AP.
Registered SM Count
This field indicates how many SMs are registered to the AP.
GPS Sync Pulse Status
This field indicates the status of synchronization as follows:
• Generating sync indicates that the module is set to generate the sync pulse.
• Receiving Sync indicates that the module is set to receive a sync pulse from an
outside source and is receiving the pulse.
• ERROR: No Sync Pulse indicates that the module is set to receive a sync pulse
from an outside source and is not receiving the pulse.
NOTE:
When this message is displayed, the AP transmitter is turned
off to avoid self-interference within the Cyclone system.
Site Name
This field indicates the name of the physical module. You can assign or change this
name in the SNMP tab of the AP Configuration page. This information is also set into the
sysName SNMP MIB-II object and can be polled by an SNMP management server.