User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 201
16.3.7 ContinuingtheTestofPoint‐to‐MultipointLinks
To resume the test of links, perform the following steps.
Procedure 10: Verifying and recording information from SMs
1. Verify that the Session Status field of the General Status tab in the SM
indicates REGISTERED.
2. While you view the General Status tab in the SM, note (or print) the values of the
following fields:
• Device type
• Software Version
• Software BOOT Version
• Board Type
• FPGA Version
3. Systematically ensure that you can retrieve this data (from a database, for
example) when you later prepare to deploy the SM to subscriber premises.
4. Return you to the Remote Subscribers tab of the AP.
5. Click the link of the next SM that you wish to test.
6. Repeat the test procedure from that point. When you have tested all of the SMs
that you intend to test, return your browser to the General Status tab of the AP.
end of procedure