User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 197
◦ Setting the Configuration Source on Page 295.
Low Priority Uplink CIR
This field displays the value that is currently in effect for the SM, with the source of that
value in parentheses. The configuration source of the value is indicated in parentheses.
See
◦ Committed Information Rate on Page 86
◦ Setting the Configuration Source on Page 295.
Low Priority Downlink CIR
This field displays the value that is currently in effect for the SM, with the source of that
value in parentheses. The configuration source of the value is indicated in parentheses.
See
◦ Committed Information Rate on Page 86
◦ Setting the Configuration Source on Page 295.
Rate
This field displays whether the high-priority channel is enabled in the SM and the status
of 1X or 2X operation in the SM. See Checking the Status of 2X Operation on Page 92.
16.3.4 BeginningtheTestofPoint‐to‐MultipointLinks
To begin the test of links, perform the following steps:
1. In the Session Status tab of the AP, note the LUID associated with the MAC
address of any SM you wish to involve in the test.
2. Click the Remote Subscribers tab.
16.3.5 RemoteSubscribersTaboftheAP
An example of a Remote Subscribers tab is displayed in Figure 59.
Figure 59: Remote Subscribers tab of AP, example