User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 187
Procedure 7: Using Quick Start to configure a standalone AP for test
1. At the bottom of the Quick Start tab, click the Go To Next Page => button.
RESULT:The AP responds by opening the RF Carrier Frequency tab.
An example of this tab is shown in Figure 53.
Figure 53: Radio Frequency Carrier tab of AP, example
2. From the pull-down menu in the lower left corner of this tab, select a frequency
for the test.
3. Click the Go To Next Page => button.
RESULT:The AP responds by opening the Synchronization tab. An example of
this tab is shown in Figure 54.