Manualshelf

User's Manual Part 2

ManualsBrandsCascade Networks ManualsElectronicsMotorola Canopy compatible Wireless Internet Acces
141142143144145146147148149150
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 296
Table 45: Recommended combined settings for typical operations
Most operators
who use…
should set this
parameter…
in this web
page…
of this
module… to…
none
Authentication
Mode
Configuration>
Security
AP
Authentication
Disabled
Configuration
Source
Configuration>
General
AP
SM
BAM Release 2.0
(Consider
upgrading to
Prizm)
Authentication
Mode
Configuration AP
Authentication
Required
Configuration
Source
Configuration AP
BAM+SM
BAM Release 2.1
(Consider
upgrading to
Prizm)
Authentication
Mode
Configuration AP
Authentication
Required
Configuration
Source
Configuration AP
BAM
Prizm Release 2.0
and 2.1
(being used for
BAM functionality)
Authentication
Mode
Configuration AP
Authentication
Required
Configuration
Source
Configuration AP
BAM
Operators whose plans are atypical should consider the results that are described in
Table 46 and Table 47. For any SM whose Authentication Mode parameter is set to
Authentication Required, the listed settings are derived as shown in Table 46.
Table 46: Where feature values are obtained for an SM with authentication required
Configuration
Source Setting
in the AP
Values are obtained from
MIR Values VLAN Values
High Priority Channel
State
CIR Values
BAM BAM BAM BAM BAM
SM SM SM SM SM
BAM+SM BAM BAM, then SM BAM, then SM BAM, then SM
NOTES:
HPC represents the Hi Priority Channel (enable or disable).
Where
BAM, then SM is the indication, parameters for which BAM does not send values
are obtained from the SM. This is the case where the BAM server is operating on a BAM
release that did not support the feature. This is also the case where the feature enable/disable
flag in BAM is set to disabled. The values are those previously set or, if none ever were, then
the default values.
Where
BAM is the indication, values in the SM are disregarded.
Where
SM is the indication, values that BAM sends for the SM are disregarded.
The high-priority channel is unavailable to Series P7 and P8 SMs that run Cyclone Release 8.
For any SM whose Authentication Mode parameter is not set to Authentication
Required, the listed settings are derived as shown in Table 47.