User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 295
See Overriding Forgotten IP Addresses or Passwords on AP, SM, or BH on Page 379.
The Unit Settings tab also contains the following buttons.
Save Changes
When you click this button, any changes that you made on all tabs are recorded in flash
memory. However, these changes do not apply until the next reboot of the module.
Undo Unit-Wide Saved Changes
When you click this button, any changes that you made in any tab but did not commit by
a reboot of the module are undone.
Set to Factory Defaults
When you click this button, all configurable parameters on all tabs are reset to the factory
settings.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
18.3 SETTINGTHECONFIGURATIONSOURCE
The AP includes a Configuration Source parameter, which sets where SMs that register
to the AP are controlled for MIR, VLAN, the high-priority channel, and CIR as follows.
The Configuration Source parameter affects the source of
• all MIR settings:
• Sustained Uplink Data Rate
• Uplink Burst Allocation
• Sustained Downlink Data Rate
• Downlink Burst Allocation
• all SM VLAN settings:
• Dynamic Learning
• Allow Only Tagged Frames
• VLAN Ageing Timeout
• Untagged Ingress VID
• Management VID
• VLAN Membership
• the Hi Priority Channel setting
• all CIR settings
• Low Priority Uplink CIR
• Low Priority Downlink CIR
• Hi Priority Uplink CIR
• Hi Priority Downlink CIR
Most operators whose plans are typical should consult Table 45.