User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 289
Untagged Ingress VID
Enter the VID that the SM(s) should use to tag frames that arrive at the SM(s) untagged.
The range of values is 1 to 4095. The default value is 1.
Management VID
Enter the VID that the SM should share with the AP. The range of values is 1 to 4095.
The default value is 1.
SM Management VID Pass-through
Specify whether to allow the SM (Enable) or the AP (Disable) to control the VLAN
settings of this SM. The default value is Enable.
The VLAN tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on this tab are recorded in flash
memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
18.2.9 VLANMembershipTaboftheSM
An example of the VLAN Membership tab in an SM is displayed in Figure 95.
Figure 95: VLAN Membership tab of SM, example