User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 282
18.2.6 QualityofService(QoS)TaboftheSM
An example of the Quality of Service (QoS) tab in the SM is displayed in Figure 92.
Figure 92: Quality of Service (QoS) tab of SM, example
In the Quality of Service (QoS) tab of the SM, you may set the following parameters.
Sustained Uplink Data Rate
Specify the rate that this SM is replenished with credits for transmission. This default
imposes no restriction on the uplink. See
◦ Maximum Information Rate (MIR) Parameters on Page 84
◦ Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
◦ Setting the Configuration Source on Page 295.
Sustained Downlink Data Rate
Specify the rate at which the AP should be replenished with credits (tokens) for
transmission to this SM. This default imposes no restriction on the uplink. See
◦ Maximum Information Rate (MIR) Parameters on Page 84
◦ Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
◦ Setting the Configuration Source on Page 295.