User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 276
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
An example of the IP tab in an SM with NAT enabled is displayed in Figure 89.
18.2.4 RadioTaboftheSM
An example of the Radio tab in the SM is displayed in Figure 90.
Figure 90: Radio tab of SM, example
In the Radio tab of the SM, you may set the following parameters.
Custom Radio Frequency Scan Selection List
Check any frequency that you want the SM to scan for AP transmissions. The frequency
band of the SM affects what channels you should select.