User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 270
LAN1 Network Interface Configuration, Network Accessibility
Specify whether the IP address of the SM should be visible to only a device connected to
the SM by Ethernet (Local) or should be visible to the AP as well (Public).
LAN1 Network Interface Configuration, Subnet Mask
Enter an appropriate subnet mask for the SM to communicate on the network. The
default subnet mask is 255.255.0.0. See Allocating Subnets on Page 162.
LAN1 Network Interface Configuration, Gateway IP Address
Enter the appropriate gateway for the SM to communicate with the network. The default
gateway is 169.254.0.0.
LAN1 Network Interface Configuration, DHCP State
If you select Enabled, the DHCP server automatically assigns the IP configuration
(IP address, subnet mask, and gateway IP address) and the values of those individual
parameters (above) are not used. The setting of this DHCP state parameter is also
viewable, but not settable, in the Network Interface tab of the Home page.
In this tab, DHCP State is settable only if the Network Accessibility parameter in the IP
tab is set to Public. This parameter is also settable in the NAT tab of the Configuration
web page, but only when NAT is enabled.
The IP tab also contains the following buttons.
Save Changes
When you click this button, any changes that you made on all tabs are recorded in flash
memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.