User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 269
Figure 87: IP tab of SM with NAT disabled, example
This implementation is illustrated in Figure 40 on Page 157. In the IP tab of an SM with
NAT disabled, you may set the following parameters.
LAN1 Network Interface Configuration, IP Address
Enter the non-routable IP address to associate with the Ethernet connection on this SM.
(The default IP address from the factory is 169.254.1.1.) If you set and then forget this
parameter, then you must both
1. physically access the module.
2. use an override plug to electronically access the module configuration
parameters at 169.254.1.1. See Overriding Forgotten IP Addresses or
Passwords on AP, SM, or BH on Page 381.
RECOMMENDATION:
Note or print the IP settings from this page. Ensure that you can readily associate
these IP settings both with the module and with the other data that you store
about the module.