User's Manual Part 2
Release8InstallationandConfigurationGuide
Issue2,November2007 Draft5forRegulatoryReview 265
Frame Timing Pulse Gated
If this SM extends the sync pulse to a BH master or an AP, select either
• Enable—If this SM loses sync from the AP, then do not propagate a sync pulse
to the BH timing master or other AP. This setting prevents interference in the
event that the SM loses sync.
• Disable—If this SM loses sync from the AP, then propagate the sync pulse to the
BH timing master or other AP.
See Wiring to Extend Network Sync on Page 374.
The General tab also contains the following buttons.
Save Changes
When you click this button, any changes that you made on all tabs are recorded in flash
memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
18.2.2 NATandIPTabsoftheSMwithNATDisabled
An example of the NAT tab in an SM with NAT disabled is displayed in Figure 86.