User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 257
VLAN Aging Timeout
Specify how long the AP should keep dynamically learned VIDs. The range of values is 5
to 1440 (minutes). The default value is 25 (minutes).
NOTE:
VIDs that you enter for the Management VID and VLAN Membership
parameters do not time out.
Management VID
Enter the VID that the operator wishes to use to communicate with the module manager.
The range of values is 1 to 4095. The default value is 1.
SM Management VID Pass-through
Specify whether to allow the SM (Enable) or the AP (Disable) to control the VLAN
settings of this SM. The default value is Enable.
CAUTION!
Do not set this parameter to Enable where both
• a BAM release earlier than 2.1 is implemented.
• the Configuration Source parameter in the AP is set to BAM.
This combination causes the SMs to become unmanageable, until you gain
direct access with an override plug and remove this combination from the AP
configuration.
Save Changes
When you click this button, any changes that you made on this tab are recorded in flash
memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.