User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 256
18.1.7 VLANTaboftheAP
An example of the AP VLAN tab is displayed in Figure 81.
Figure 81: VLAN tab of AP, example
In the VLAN tab of the AP, you may set the following parameters.
VLAN
Specify whether VLAN functionality for the AP and all linked SMs should (Enabled) or
should not (Disabled) be allowed. The default value is Disabled.
Dynamic Learning
Specify whether the AP should (Enabled) or should not (Disabled) add the VLAN IDs
(VIDs) of upstream frames to the VID table. (The AP passes frames with VIDs that are
stored in the table both upstream and downstream.) The default value is Enabled.
Allow Frame Types
Select the type of arriving frames that the AP should tag, using the VID that is stored in
the Untagged Ingress VID parameter. The default value is All Frames.