User's Manual Part 2

Release8InstallationandConfigurationGuide


Issue2,November2007 Draft5forRegulatoryReview 251
18.1.5 QualityofService(QoS)TaboftheAP
An example of the Quality of Service (QoS) tab of the AP is displayed in Figure 79.
Figure 79: Quality of Service (QoS) tab of AP, example
In the Quality of Service (QoS) tab, you may set AP bandwidth parameters as follows.
Sustained Uplink Data Rate
Specify the rate that each SM registered to this AP is replenished with credits for
transmission. This default imposes no restriction on the uplink. See
◦ Maximum Information Rate (MIR) Parameters on Page 84
◦ Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
◦ Setting the Configuration Source on Page 295.
Uplink Burst Allocation
Specify the maximum amount of data to allow each SM to transmit before being
recharged at the Sustained Uplink Data Rate with credits to transmit more. See
◦ Maximum Information Rate (MIR) Parameters on Page 84
◦ Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
◦ Setting the Configuration Source on Page 295.