User's Manual Part 1
Release8OverviewofCycloneNetworks
Issue2,November2007 Draft5forRegulatoryReview 59
Alternatively if you wish, you can fabricate an override plug. For instructions, see
Procedure 36 on Page 380 and the pinout in Figure 140 on Page 380.
Alignment Headset
The ACATHS-01 Alignment Headset facilitates the
operation of precisely aiming an SM toward an AP (or
a BHS toward a BHM). This device produces infinitely
variable
• pitch, higher when the received signal is
stronger.
• volume, louder when jitter is less.
An ACATHS-01 is pictured in
Figure 16.
Pinouts for an alternative listening device are provided
under
Alignment Tone—Technical Details on
Page
184.
Figure 16: ACATHS-01
alignment headset
Module Housing
The HSG-01 Cyclone Plastic Housing is available for
replacement of a damaged housing on a module that is
otherwise functional. The HSG-01 is pictured in
Figure 17.
The HSG-01 and all module housings of this design
provide clearances for cable ties on the Ethernet and sync
cables.
RECOMMENDATION:
Use 0.14” (40-lb tensile strength) cable ties
to secure the Ethernet and sync cables to
the cable guides on the module housing.
For the Ethernet cable tie, the Ethernet cable groove is
molded lower at the top edge. For the sync cable tie,
removal of a breakaway plug provides clearance for the
sync cable, and removal of two breakaway side plates
provides clearance for the sync cable tie.
Figure 17: HSG-01 Housing