User's Manual Part 1
Release8OverviewofCycloneNetworks
Issue2,November2007 Draft5forRegulatoryReview 58
BT-0563 RJ-11 TO RJ-11; sync cable
BT-0563S RJ-11 TO RJ-11; shielded sync cable
NOTE:
Shielded cable is strongly recommended for all AP cluster and BH installations.
Table 9: Recommended indoor UTP Category 5E cables
Best-Tronics
Part # Description
BT-0596 RJ-45 TO RJ-45; straight-through Ethernet cable
BT-0595 RJ-45 TO RJ-45; crossover Ethernet cable
Approved Ethernet cables can also be ordered as bulk cable:
• CA-0287
• CA-0287S (shielded)
Cyclone-approved antenna cables can be ordered in lengths up to 100 ft (30.4 m),
as listed in
Table 10.
Table 10: Recommended antenna cables
Best-Tronics
Part # Description
BT-0564 N TO N GPS antenna cable for CMM2
BT-0716 BNC TO N GPS antenna cable for CMMmicro
Category 5 Cable Tester
For purchase within the U.S.A., the CTCAT5-01 Cable Tester is available.
Override Plug
An override plug (sometimes called a default plug) is available to provide access to a
module whose password and/or IP address have been forgotten. This plug allows the AP,
SM, or BH to be accessed using IP address 169.254.1.1 and no password. During the
override session, you can assign any new IP address and set either or both user
passwords (display-only and/or full access) as well as make other parameter changes.
This plug is available from Best-Tronics Manufacturing, Inc. at
http://www.best-tronics.com/Last Mile Gear.htm
as Part BT-0583 (RJ-11 Default Plug).