User's Manual Part 1

Release8OverviewofCycloneNetworks



Issue2,November2007 Draft5forRegulatoryReview 112
VLAN Management Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Configurable VLAN
AP SM
CMMmicro
Configuration/VLAN yes
Highly configurable VLAN (802.1Q) AP SM Configuration/VLAN yes
Use of VLAN priorities (802.1p) with high
priority channel
AP SM no yes
Port-based VLAN switching on CMM CMMmicro Configuration yes
VLAN statistics AP SM Statistics/VLAN yes
Dynamic Frequency Selection (DFS)
Feature
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
DFS v1.2.3 All radios no yes
Time Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Time and Date from CMM via Network Time
Protocol (NTP) server
AP BHM Configuration/Time yes
Time and Date manually settable AP BHM Configuration/Time yes
CMM provides NTP server CMMmicro no no
Spectrum Analyzer Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Spectrum analyzer SM BHS Tools/Spectrum Analyzer no
Ability to switch an AP to an SM (or BHS to
BHM)
AP BHM Configuration/General yes
Aim/Link Quality Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Alignment tone for using during
aiming/alignment
SM BHS no no
Aiming support page when not using
alignment tone
SM BHS Tools/Alignment
multiple
objects
LED for alignment SM BHS no no
Configure SM power-up state - aiming or
operational
SM BHS Configuration/General yes
Link capacity test, with configurable packet
length
All radios Tools/Link Capacity Test yes
Display of SM configuration information at
AP
AP BHM Home/Session Status yes
Display/evaluation of AP beacon data from
all receivable APs
SM BHS Tools/AP Evaluation yes
Over-the-air radio Bit Error Rate (BER)
indicator
All radios Tools/BER Results yes