User's Manual Part 1

Release8OverviewofCycloneNetworks



Issue2,November2007 Draft5forRegulatoryReview 111
Bandwidth Management Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
AP Maximum Information Rate (MIR) default
settings
AP Configuration/QoS yes
Per SM Maximum Information Rate (MIR) SM Configuration/QoS yes
Per SM Committed Information Rate (CIR)
for high and low channels
SM Configuration/QoS yes
"Configuration Source" for
MIR/CIR/HP/VLAN can be either SM or
BAM/Prizm
AP Configuration/General yes
CIR for low priority channel on BH BHS Configuration/QoS yes
Configurable priority for TCP Acks, to
optimize bandwidth use
AP BHM Configuration/General yes
Bandwidth Management Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Configurable High Priority channel with
configurable DiffServ mappings on AP, SM
(2 classes of service)
AP SM Configuration/DiffServe yes
Permanent BH High Priority Channel with
configurable DiffServ mappings on BH
(2 classes of service)
BHM BHS Configuration/DiffServe yes
Virtual channel (high/low priority) statistics All radios Statistics/Data VC yes
Network Address Translation (NAT)
Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
NAT SM Configuration/NAT yes
NAT DMZ SM Configuration/NAT yes
NAT DHCP server on LAN with up to 254 IP
addresses in pool
SM Configuration/NAT yes
NAT DHCP client on WAN (obtains NAT
address from a DHCP server)
SM Configuration/NAT yes
NAT port mapping SM Configuration/NAT yes
VPN "pass through" for L2TP over IPSec
(but not PPTP)
no no
NAT statistics SM Statistics/NAT Stats yes
NAT DHCP statistics SM Statistics/NAT DHCP Statistics yes
NAT table SM Logs/NAT Table no
Filtering Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Protocol filtering based on protocol SM Configuration/Protocol Filtering yes
Operator-defined port filtering (3 ports) SM Configuration/Protocol Filtering yes
Packet filter statistics All radios Statistics/Filter yes