Data Sheet

casambi.com
19
Information in this document is subject to change.
CBM-003B preliminary datasheet ver 0.91
Casambi Technologies Oy
Bertel Jungin aukio 1 E, 02600 Espoo, Finland
Copyright Casambi Technologies Oy
17. End Product Labeling 18. Notes
Note 1:
This module certified that complies with RF
exposure requirementunder mobile or fixed condition,
this module is to be installed only in mobile or fixed
applications. A separate approval is required for all
other operating configurations, including portable con-
figurations with respect to Part 2.1093 and difference
antenna configurations. This transmitter must not be
co-located or operating in conjunction with any other
antenna or transmitter.
Note 2:
Any modifications made to the module
will void the Grant of Certification, this module is
limited to OEM installationonly and must not be sold
to end-users, end-user has no manual instructions
to remove or install the device, only software or
operating procedure shall be placed in the end-user
operating manual of final products.
Note 3:
Additional testing and certification may be
necessary when multiple modules are used.
Note 4:
The module may be operated only with the
antenna with which it is authorized. Any antenna that
is of the same type and of equal or less directional
gain as an antenna that is authorized with the
intentional radiator may be marketed with, and used
with, that intentional radiator.
This product must be professionally installed to
ensure that no antenna other than that furnished by
the responsible party shall be used with the device
Contains FCC ID: 2ALA3-CBM003C
Contains IC: 22496-CBM003C
Contains FCC ID: 2ALA3-CBM003B
Contains IC: 22496-CBM003B
CBM-003B/C has been labeled with its own FCC
ID and IC Certification Number. The end product
manufacturer must ensure that FCC and ISED labeling
requirements are met. If the FCC ID of 2ALA3-CBM003B/
22496-CBM003B / 22496-CBM003C are not visible
when the module is installed inside another device,
then the device must have a clearly visible label
containing the following information:
CBM-003B/C a été identifié avec son propre numéro
d’identification de la FCC ainsi que son numéro de
certification IC. Le fabricant du produit final doit assurer
que les obligations d’identification de la FCC et des
indicateurs du développement énergétique durable
soient satisfaites. Si le numéro d’identifcation FCC de
ne sont pas visibles lors
de l’installation du module dans
l’appareil:
2ALA3-CBM003C and IC Certification Number of
2ALA3-CBM003B / 2ALA3-CBM003C
et lenuméro de
certifcation IC de 22496-CBM003B / 22496-CBM003C
un autreappareil, une
étiquette claire et visible avec les
informations
ci-après devra alors être apposée sur