Use and Care Manual

1.Please check that all components are present.
2.Before installation ensure that all feed lines are clear of debris and
on/off valve is present.
3.Ensure water pressure is between 20-125 PSI (includes combination
of hot and cold feed lines).
4.Pictures in the manual are general in content and may not represent
exactly your purchased faucet. If you are having difficulties please
contact a professional plumber.
5.If you will be away from home for an extended period you should
shut off the main water supply.
6.Please insure that to make a wash for all water pipe before
installation to insure no impurity inside.
7.When you need to welding the shower valve to the water pipe of the
valve , please remember to take out the cartridge and any seal parts of
the valve . When finish welding , need to wait for body of the valve
cool down and then install the cartridge and the seal parts.
8.Need to used the 11-13N.m power to lock the cartridge.
All valve have the pass the the air testing and
pressure testing before ship out. If request presssure
testing before installation,Must under the guide of the
professional Plumber with license. And air pressure
do not over 125PSI. lf you want to the Brust testing
over 50±2PSI,you need to changed a new cartridge for
normal using.
Installation steps
1
2
3
3. Lock the install protective cover into the body.
(155*100mm oval type).
4.Please cut the size of the tile hole according to the size
and shape of the protetived cover( about 5mm bigger than
the protetived cover from each side) .And please put the
tile outside the wooden wall(please noted that we keep
the same central point for the tile hole with the protetived
cover).
5. Loosen the screw and remove protect cover.
Adjustable wrench Philips Sorewdriver
Hexagon wrenchPipe tape
4
5
6
CARTRIDGE
STANDARDS
• Pressure Balance cartridge
• Third party certified to meet ASME A112.18.1
all applicable requirements referenced therein
• ADA for lever handle
Installation steps
Important
6.Lock the deck plate into the body and cling to the
wall,then tight the screw.
1.. Confirm the installed place of the pressure balan
valve and fixed on the wood block .
2.. Connect the hot&cold inlet tube and outlet tube,th
make sure the tube fix stable on the wooden wall.
Handle shower
outlet water
Top shower
outlet water
Hot water
Cold water