User manual

Macro System US is not responsible for any radio television interference caused by unauthorized modifications of this
equipment or the substitution or attachment of connecting cables and equipment other than those specified by Macro
System US. The correction of interference caused by such unauthorized modification, substitution or attachment will be the
responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional peripheral or host devices.
Failure to do so may violate FCC rules.
This Class A digital apparatus meets also all requirements of the Canadian Interference-Causing Equipment Regulations
(ICES-003).
FCC Class B Compliance Statement (Avio, Renommee, Renommee PLUS)
Information to the User
NOTE:
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the
FCC Rules and meets all requirements of the Canadian Interference-Causing Equipment Regulations (ICES-003). These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/T.V. technician for help.
MACROSYSTEM US is not responsible for any radio or television interference caused by unauthorized modifications
of this equipment or the substitution or attachment of connecting cables and equipment other than those specified by
MACROSYSTEM US. The correction of interference caused by such unauthorized modification, substitution or attachment will
be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional peripheral or host devices.
Failure to do so may violate FCC and ICES rules.