User manual

The following products carry the CE seal of conformity on the basis of the guidelines 89/336/EWG of the Commission of the European Community from
29. April 1991 for the alignment of legal regulations in the signatory states concerning communications devices, including mutual recognition of their
conformity. The following products are confirm to the low voltage directive 2006/95/EC.
These digital video editing systems are meant for use with hard-drives carrying the CE seal of conformity.
This statement is given in responsibility for the manufacturer: MacroSystem Digital Video AG, Schöllinger Feld 28, 58300 Wetter, Germany
Remarks on Safety
These devices conform to the relevant safety regulations for computer equipment, including electrical office machines. In case you are in doubt as to
permission regarding setup in the intended surroundings, please contact your dealer or our service department.
• Transport the device only in the original packing or in other appropriate packing that guarantees protection against sudden movements
or impacts.
• Condensation may result if the device is set up for operation after having been in colder surroundings. You should wait about 2 hours to
let the device become dry and attain the temperature of the operating location.
• Read the notes below "Location Environment" when setting up and before operating the device.
• Check that the operating voltage indicated on the type label is the same as the power outlet.
• The equipment is intended for connection to TN power system and IT power system for Norway only (phase to phase 230V).
• The equipment is a class 1 equipment and must be connected to an earthed outlet.
• This device is equipped with a safety-approved power cable and may only be connected to a grounded shockproof socket.
• The ON/OFF switch does not electrically separate the device from power. For complete separation from power the power cable must be
pulled from the power outlet socket.
• Make sure that the power connector on the machine and the room shockproof socket are easily accessible.
• Place the power cables so that they are not a danger (tripping) and will not be damaged.
• Data lines must not remain connected during electrical storms.
• In emergencies (e.g. damaged casing, operating elements, or power line, liquid poured on the device, or foreign substances) you must
turn off the device immediately, pull the power plug, and contact your dealer or our service department.
• Only qualified and authorized personnel may repair the device or install extensions. Unauthorized opening and improper repairs can mean real
danger for the user. In such cases the guarantee is no longer valid.
• The equipment was evaluated for use in a maximum ambient temperature of 35°C.
• System extensionsmust be conform to the requirements and rules for safety, electromagnetic interference, and telecommunications end devices. In-
stalling other extensions may violate these requirements and rules, or damage the system. Your dealer or our service department can tell you which
system extensions are allowed.
• The unit contains a Lithium battery. It may only be removed or exchanged by authorized personnel. Incorrectly replacing the battery may
lead to the battery exploding. Replace the battery only with the same or equivalent type recommended by the manufacturer. Dispose of
used battery according to the manufacture‘s instructions.