Quick Start Guide

Apex™ Lifestyle Small Cell: Triangle
Quick Start Guide
Copyright 2019 Casa Systems P/N 3098-01 Rev 4.0
Installation steps:
1. Connect the power supply to the unit and plug the other
end of the power supply into an available electrical outlet.
A 120v, 60Hz, surge protected circuit is recommended.
Power Supply connector
2. Connect the Ethernet cable to the unit.
Ethernet port
3. Connect the other end of the Ethernet cable to a LAN port on the
home router or connect it to the Ethernet outlet that has service.
The unit will power on.
Triangle Status & LED Behavior
Triangle Status
LED
Device startup
fixed red
Device activating
blinking blue
Activation complete
fixed green
Device in use
blinking green
Error condition
blinking red
Take a break
Once the unit setup is complete, the unit will go through a self-installation
process during which software and configuration settings will be installed.
This process could take up to 60 minutes.
Canada ISED Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-
exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference;
2. This device must accept any interference, including interference that
may cause undesired operation of the device.
IC: 24053-LTE100304
L’émetteur/récepteur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne
ICES-003
CAN ICES-3 (B) / NMB-3 (B)