Owner`s manual

SOUND OPTIONS
These options apply only when the HDMI 1 video output of the Cinema 11v is connected
to the main video display while the HDMI 2 video output is connected to the main HDMI
audio input of the surround sound processor as suggested in the CONNECTIONS section
of this manual. Also, please refer to the EDID channel section of Advanced Settings for
more explanation of the EDID function.
SOUND THROUGH A TELEVISION
• EDID of the Cinema 11v is preset to HDMI 2. Change the EDID to HDMI 1 to
allow sound to pass to the television.
• Make sure surround sound processor is turned off.
SOUND THROUGH A SURROUND SOUND PROCESSOR
• Be sure the EDID is set to HDMI 2.
• Turn on the surround sound processor. In this mode, no sound will pass to the
television.
RESTORING SOUND TO A TELEVISION
• Mute or turn down the sound on the surround sound processor.
• Set the EDID back to HDMI 1.
• Select a new video input on the Cinema 11v, if desired.
• Turn off the surround sound processor.
Please Note: IF EDID is set to HDMI 1 as required for television sound while the
surround sound processor is turned on, the surround sound processor will receive an
LPCM signal and may cause extraneous noise through the surround sound speakers. To
avoid this, either set the EDID to HDMI 2 prior to turning on the surround sound
processor or set the surround sound processor input to receive an LPCM signal.
34