UH6000 UHF Wireless Microphone System 12340 World Trade Dr. San Diego, CA. 92128 800-854-2235 carvin.
Carvin’s Limited 90 Day Warranty Carvin warrants to the original purchaser that your unit is free from any defects in material or workmanship for a period of 90 days from the date of purchase. If any such defect is discovered within the warranty period, Carvin will repair or replace the unit free of charge, subject to verification of the defect or malfunction upon delivery. Important: All items for service are to be return to Carvin (shipped prepaid), 12340 World Trade Dr., San Diego CA.
INTRODUCTION Thank you for purchasing a Carvin UHF Diversity Wireless Microphone System and congratulations on your choice. The UH6000 is the best performance and price value available in rackmount UHF wireless systems and is loaded with features: • Clear channel operation on the wide open, uncluttered UHF band for interference-free performance in any application or locale. • Carvin’s companding circuitry for an industry best 120dB Dynamic Range, and the clearest, most natural sound available.
UH6000 RECIEVER 1. Rackmounting the Receiver The UH6000 is supplied with RACK EARS (17) which can be attached with the screws provided on the front of the side panels to enable rackmounting the receiver. (Note: Do not mount the receiver in a rack directly above an amplifier or other source of high heat. Always ensure adequate air flow and heat dissipation in any rack configuration. 24 34 26 3. Antennas The UH6000 receiver is supplied with two detachable ANTENNAS (16).
5. Connecting the Audio Output The URR-10 receiver provides both a fixed mic level BALANCED AUDIO OUTPUT XLR (14) and an adjustable line level UNBALANCED AUDIO OUTPUT 1/4" JACK (13). The level from the UNBALANCED OUTPUT is controlled by the front panel VOLUME CONTROL (6) and the rear panel LEVEL LOW/HI SWITCH (12). This switch adjusts the maximum volume of the level range controlled by the VOLUME CONTROL.
The AF LEVEL LED DISPLAY (5) on the receiver will light up to 5 LEDs for all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, turn down the instrument volume or the INPUT LEVEL CONTROL (33) on the transmitter, or noticeable distortion may result. (Note: Scratchy noises can sometimes occur when some electric guitars with dirty pots or connections are used with any wireless system.
BODYPACK TRANSMITTER HANDHELD MICROPHONE 1. Unscrew the BATTERY COMPARTMENT COVER (19) and remove, exposing the BATTERY HOLDER (20). Insert a fresh 9V ALKALINE BATTERY (21), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can last up to 10 hours in use, but in order to ensure optimum performance, it is recommended that you replace the battery after every 7-8 hours of use. 2.
