This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CARVIN ENGINEERING DATA LC24 24CH LIGHTING CONSOLE OPERATING MANUAL the desired chase speed. The SPEED FADER will over ride a Tap Sync setting as soon as it is moved. The case speed is off when the Speed fader in the minimum position called Show Mode this can be over written with the Tap Sync button, simply move the speed fader up and back down to stop again. In this position the Step button can be used to go trough the programs steps one step at a time.
LC24 24CH LIGHTING CONSOLE F. DELETING PROGRAMS: Delete all programs– "clear memory" Press and hold the RECORD button, now press in sequence the channel FLASH BUTTONS 1, 3, 2, and 3 while still holding the record button. Release the record button, now all programs are erased. Delete a single program • Enter record mode. • Set the mode to Scenes by pushing the MODE SET button until the LED for the Scenes mode is lit. • Press the PAGE button until the page LED until the desire program range is lit.
1 31 30 29 28 27 26 25 24 23 2 22 21 3 20 4 19 18 5 6 7 8 released the scene program is locked so that chase speed and other programs can be set to new chase speeds. To return a Scene program’s chase speed control to the speed fader, place the Speed fader in the bottom SHOW MODE position. Press and hold the REC SPEED button along with the Scene programs FLASH button upon release of both buttons the control is restored. 26.
