User's Manual

AG501 cs5cal (PD-02.05)
Page 3 of 11
Fig.6: Close-up on the sensors
Fig.7: Alignment of the sensors
Loosen the two screws of the magazine and put in the sensors as shown in Fig.4 to Fig.7.
The first magazine holds sensor 1 to sensor 4, counted from right to left. The second magazine holds
sensors 5 to 8, and the third magazine holds sensors 9 to 12.
Make sure that the location of each sensor corresponds to the channel it is connected to!
Tighten the screws of the magazine until the sensors stay steady in place without shaking. Do not put
too much pressure on the sensors.
Fig.8:
Put the magazines in the
corresponding gaps ….
C. Insert the sensor plugs
Fig.9: Connect the sensors
front