User's Manual

CSP-100B Installation Manual
CP5033A Page 2 of 2 11/13/09
INSTALLATION
Proper installation of the unit is essential for years of safe, reliable operation. Please read all instructions before installing the unit. Failure to
follow these instructions can cause serious damage to the unit or vehicle and may void warranties.
SAFETY PRECAUTIONS
For the safety of the installer, vehicle operator, passengers and the community please observe the following safety precautions. Failure to
follow all safety precautions and instructions may result in property damage, injury or death.
Qualifications - The installer must have a firm knowledge of basic electricity and vehicle electrical systems.
Sound Hazard - Sound level from loudspeaker (>120dBA @ 10 feet) may cause hearing damage.
Do not operate system without adequate hearing protection for you and anyone in immediate vicinity.
(Ref. OSHA 1910.95 for occupational noise exposure guidelines)
Mounting - DO NOT mount unit in front of air bag sensors. Assure clearances before drilling in vehicle.
Wiring - Use wiring capable of handling the current required. Make sure all connections are tight. Route wiring to prevent wear, overheating
and interference with air bag deployment sensors.
Testing - Test for proper system operation. Test vehicle operation to assure no damage to vehicle.
Keep These Instructions - Keep instructions in the vehicle or other safe place for future reference. Advise vehicle operator of the location.
MOUNTING LOCATION
The loudspeaker is weather resistant and is intended to be mounted on the outside of the vehicle or under front hood. Mount the loudspeaker
facing forward and as far forward on the vehicle as possible to minimize sound exposure to occupants. Choose a location that minimizes
obstructions in front of the loudspeaker to maximize forward sound. Attach the loudspeaker to a sturdy part of the vehicle to prevent vibration
and possible damage. Attach the loudspeaker angled slightly toward the road so the front openings will drain off any fluids.
Cover openings of loudspeaker while drilling any holes. DO NOT get metal shavings inside the loudspeaker.
ELECTRICAL CONNECTIONS
Connect the loudspeaker as described in amplifier installation manual. Use only high quality crimp connectors.
DIMENSIONS
IN INCHES
L BRACKET
CSP-100B
100W 11 OHM
WHT
WHEN WIRING TWO SPEAKERS
CONNECT SAME COLORS
FOR MAXIMUM SOUND OUTPUT
AMPLIFIER
WHT
BRN
BRN
WIRES FROM AMP
#18G FOR ONE SPK
#16G FOR TWO SPK