Operating instructions

Page 6 of 16 Installation and Operating Instructions SC-411HS-20
4/1/14 CP5122A
OPTION SETTINGS
Enter/Exit Program Mode, Reset
Option setting (programming) is done from the face of the handheld controller. Unit must be turned on with
POWER input. Make sure that all buttons are off.
Enter the program mode by pressing and holding S1, S2 and DIM for
3 seconds
The unit will beep 3 times and the backlighting
will begin flashing to indicate that the unit is in
program mode. It will continue to flash until
program mode is stopped by pressing and
holding DIM for 3 seconds, saving the set-
tings—the unit will emit a long beep.
Press and hold for 3 seconds
to reset to factory default.
Press for next step.
Press and hold for 3
seconds to exit.
Program Mode Sections
Press DIM Display Programming
0↓
+ + , or or
S1-S6 Button Operation, Primary / S1-S6 Button Linkage
1↓
blinking
Option Set 1 (Input polarity, timed, swp/int, auto)
2↓
blinking
Option Set 2 (Tone enables, short manual, lever progression)
3 0
blinking
Option Set 3 (Alert, siren/lever video)
DIM
S2 S1
DIM


